Rod Ends

Heavy duty tie rod ends. These are specifically made for four wheelers. These ends are greasable for a long lasting life. Each nut is zinc plated to resist corrosion. The rubber boot is high quality with snap rings top and bottom. The left hand threaded end comes with a left hand threaded jam nut, most ends don’t, and the cost of these nuts is usually several dollars when sold separately.

Specifications:
Length: 5 7/8 inches
Shaft Length: 3.5 inch threaded
Shaft Diameter/Thread: 7/8 – 18
Jam Nut: .5 inch width

This part has the same tapered stud as following vehicles:
Chevrolet 1/2 ton solid axle truck tie rod
Chevrolet 3/4 ton solid axle truck tie rod
Chevrolet 1 ton solid axle truck tie rod
Chevrolet solid axle Blazer tie rod
Chevrolet solid axle Suburban tie rod
Jeep Wagoneer Dana 44 tie rod
Jeep J Truck Dana 44

This is part can be used to replace the following Moog part numbers:
ES2234R
ES452L
ES453L
ES2010L
ES2010R

Note: These are not Chevrolet drag link ends. Chevrolet drag link ends have a slightly larger tapered stud and have a few more degrees of movement.